|
|
SUPPORT ZPOST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
Post Reply |
|
Thread Tools | Search this Thread |
02-01-2016, 11:44 AM | #1 |
Lieutenant General
2280
Rep 12,565
Posts
Drives: Z4 M, X5, GX460
Join Date: Apr 2008
Location: CT
iTrader: (99)
Garage List F15 X5 xDrive35i [8.75]
E86 Z4 M [10.00] F10 550i (Retired) [9.17] F25 X3 xDrive35i (R ... [9.43] E82 135is (Retired) [9.50] E85 Z4 M (Retired) [9.41] E90 328i xDrive (Re ... [9.25] E86 Z4 3.0si (Retired) [9.20] |
Clear Adaptations for New Mods Causes Temporary CEL
I installed a Dinan throttle body a while back. As per Dinan's recommendation, I reset the throttle adaptations but I still got a CEL. It eventually went away after a full drive cycle...
Fast forward few months and I had to reset my throttle adaptations again and sure enough my CEL reappeared. You would think clearing adaptations gives the DME a clean slate but it's as if the CEL is triggered by the fact the new hardware gives readings different from stock? And it's only after a full drive cycle, the DME adjusted for the new TB. Thoughts? Last edited by 3002 tii; 02-01-2016 at 10:26 PM.. |
Post Reply |
Bookmarks |
|
|