|
|
SUPPORT ZPOST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
Post Reply |
|
Thread Tools | Search this Thread |
10-18-2019, 10:12 AM | #1 |
Enlisted Member
4
Rep 35
Posts |
E86 non M - Style 203 square
Thinking about using a square setup of the rear factory Style 203 wheels. Has anyone run this setup before? Going from a 8.0 +47 to a 8.5 +50 doesn't seem like a big deal, but would like to not rub at all. Stock suspension (M sport), ideally 235/40 all round. Thanks!
Last edited by Spec-Al; 10-18-2019 at 10:24 AM.. |
10-20-2019, 07:27 AM | #2 |
Lieutenant General
2387
Rep 12,635
Posts
Drives: Z4 M, X5, GX460
Join Date: Apr 2008
Location: CT
iTrader: (100)
Garage List E86 Z4 M [10.00]
F15 X5 xDrive35i [9.17] F10 550i (Retired) [9.17] F25 X3 xDrive35i (R ... [9.43] E82 135is (Retired) [9.53] E85 Z4 M (Retired) [9.41] E90 328i xDrive (Re ... [9.25] E86 Z4 3.0si (Retired) [8.93] |
Without camber 235 may run because of the increased height. It’s been a while but I think mine rubbed the outer edge of the liner where the bumper and fender meet.
|
Appreciate
0
|
10-21-2019, 11:20 AM | #4 |
Lieutenant General
2387
Rep 12,635
Posts
Drives: Z4 M, X5, GX460
Join Date: Apr 2008
Location: CT
iTrader: (100)
Garage List E86 Z4 M [10.00]
F15 X5 xDrive35i [9.17] F10 550i (Retired) [9.17] F25 X3 xDrive35i (R ... [9.43] E82 135is (Retired) [9.53] E85 Z4 M (Retired) [9.41] E90 328i xDrive (Re ... [9.25] E86 Z4 3.0si (Retired) [8.93] |
Not even it’s only 1/3” taller but with wide enough rubber it’ll rub in the right spot. But if you pull the camber pins that should be enough to pull it away from the liner.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|