Quote:
Originally Posted by inTgr8r
I would tape it up first.
A layer of painters tape then a layer of duct tape on top of that.
|
QUOTE=sabbanick;10011328]^^that might work^^ ... I had some first hand experience at this using some hi test fishing wire...it generate soo much heat "sawing" it through the silicone. Its frustrating work!
Based on the attention to detail, and how thought out Dark Schnitzer has been with building this part. There is little doubt that he will provide a thorough DIY.
P.S. Sorry not trying to derail your thread, im still a potential buyer![/QUOTE]
For sure...a layer of tape whether it masking or aluminum will add confidence and safety as one concentrates on slicing through the 1/4" or so of sealant.
Maybe even a thin piece of sheet metal to move along as a tool. Its all relative to doing an odd job really. To some...its easy, others a struggle.
Hopefully...a DIY with pix will even the field and raise confidence.