Some added comments. The best way to remove the high beam wire is to pull the HID housing out a little to gain access and then pull the stubborn thing off. Don't break it.
Also, don't tighten anything too tight or you'll break the plastic. Just nicely snug.
Don't lose those little green spacers that might stick to the HID housing.
Lastly, align your lights when you're finished with the reinstall. They might need a small adjustment. My driver side was way too high. It could've been too high prior to any of this but I didn't know because it was too dim.
I shot these videos all in one take so bear with me trying to do everything with one hand.
Here is where I ordered them.
http://www.lightwerkz.net/index.php/...lear-lens.html
They are the ZKW-R 3" lenses.
Here are the videos.