[rejjie]

Originally Posted by rjj

FIXED!!!

One of the wires going up to the hall sensors (at the front of the roof) broke. It broke near the front of the roof, right where the first fold is (see pictures). I needed to take the plastic panel off in order to get to the wire (it's hanging in the pictures below). Also, I had to cut that braided sleeve that holds the wires together. You won't be able to see anything without cutting it... it looks perfect on the outside. This is the second time I've seen that the break happened at the same location. I hope this helps someone and saves them some time


The plastic panel hanging in order to get access to the wiring (hanging):





The break in the wire is to the right of my hand here (you can see where I cut wiring sleeve):




You can clearly see the broken wire... it was one of the thin ones naturally.

Hi rjj. The photos you posted no longer appear on the post. Do you happen to still have those photos available and can re-post or send? I have the same problem, and I would very much appreciate the photos. Thank you in advance.