[xg3]

So, lets get some update going.

Tweeter installation required me to beat up the factory tweeter holder, open up the hole to mount the tweeter. The factory tweeter is glue'ed into place (kinda stupid if you ask me). The opening of the hole is approx 1", however there is a smaller mounting plate inside, that reduces the hole to about .5" (the size of the tweeter dome).

Mid bass installation went without a hitch. easy. direct fit.

Front low bass, required drilling of a new screw holes, but again was relatively easy to accomplish.

Subwoofer, the JL 6w3v3 WILL NOT fit, it does not clear the depth of the factory enclosure, by approximately .5".

Wirings, probably the easiest part of the job, follow the Tutorial on this site somewhere. cut / slice and connect. No brainer.

Will have pics soon!