Thx Micheal,
I looked at including the diagonal bar, but as my main roll loop is mounted on the bulkhead, the main loop only being rather short,
it would start at the top drivers side and end at the height of the harness bar on the pax side. there isn't much point in adding this bar to my setup at this stage. It is possible to add, however, this could be done afterwards if required, by cutting the harness bar and adding in the diaganol bar. Not sure if that makes sense reading it, but I'll add a picture or two in a bit. Also, as this is most likely to stay a track car for its remainder of its life, I am still struggling with adding a lot of weight. Youll also note the cross bracing is missing from the roof section, and there is no cross bracing on the members going rear ward from the main roll hoop. I removed about 2/5ths of the rear bulk head, as I wanted to retain the factory rigidity.
Last edited by Vanne; 09-20-2019 at 06:22 PM..
|