Quote:
Originally Posted by mattfwalters
If what I've read - that Megan Racing bought one of the Chinese manufacturers that was selling headers on eBay (Merz-somethingoranother?) - is true, then these are the headers that I have installed in my Z4MC. They definitely look like the same design and manufacturing quality (about which I was pleasantly surprised) as mine.
I *am* chasing an exhaust header leak right now, which may or may not be my own damn fault, but at least visually these headers lined up and bolted down easily / flatly enough. The gaskets that they came with were garbage so I just threw them out, FWIW.
|
Quote:
Originally Posted by WeekendWarriorz
I've read on m3forum that they have taken the exact same headers as active autowerke and just tweaked them slightly. Pretty sure they sourced them from the same factory too. The thread on m3forum for these headers are 110+ pages long and I read every single post about it, back in early 2018 there was a cylinder 6 header issue with the bolts lining up which was fixed last summer of 2018. Tons of people have been using these with no issues. The EGT on these are located in a different spot and the bungs are positioned correctly
|
Yeah, I think this may be the same thing. I bought the Manzo headers from eBay about 5 years ago and am experiencing all of the same problems that folks have complained about with their earlier builds. Nice welds, install flat enough, but warp with use. Given the rest of my build I have opted for the $uper$print $tepped option but I'm as excited as everyone else to hear how the Megan units measure up.