|
Thanks, your post was really helpful. I caught a small wiring mistake ahead of time on mine to make sure I got the correct one from the harness going to pin 13. Sounded great as soon as I started it up.
I know this is an old post but was curious how you got the head unit to sit flush on the face plate? I am using an aftermarket kenwood receiver too and the Metra face plate. Face plate is in, but when I try to put the head unit in, it is angled and the top part of the head unit stickst out about 1/4 to 1/2 inch compared to being flush at the bottom. It appears to be sitting on top / bumping into brackets inside the dash that forces it more level and thus stick out of the angled face plate.
|