View Single Post
      07-05-2019, 04:32 AM   #371
Vanne
Down Under!!
Vanne's Avatar
United Arab Emirates
1593
Rep
4,293
Posts

Drives: 2007 Z4MC
Join Date: Mar 2013
Location: Dubai

iTrader: (4)


On its way with a shit load of updates to be listed, just been super lazy in the off season. Parts have been arriving, just been involved a bit with my /other/ hobby that takes place when it's too stinking hot to go outside.

Initial cooler before modding (not mine, just a pic from the web)

The reason for the removal of the return line is that I have a secondary oil cooler in my right fang. So this loop will go from main to secondary back to the oil pump.





An10 M20 fittings welded /taped onto new CFL oil cooler


New Thermostat. And also a new oil pump diverter valve delete.


Also new braided clutch line, and new Sachs clutch actuator. New front wheel bearings (due to a stud spin on a hub )
Lots of other little things, new dash control is a work in progress.



S54 AN10 hook up for the oil pump engine side.

new Braided clutch line
new sachs clutch slave
APR extended wing struts
new front wheel bearing/hub
bunch of an10 fittings and braided oil lines

AS PART OF THE GEAR KIT:
------------------------------

33121205138 securing plate for pinion (TURNER)
33121204657 crush sleeve (TURNER)
33107510289 output seals X2 (TURNER)

TMK-HM803110 bearing race - ( From summit racing )
TMK-HM803149 inner pinion bearing - (From summit racing )
-------------------------------------------------------
(thanks goes to Ron for the extra part numbers and research that he did into which bits are needed)

As a side note, my dash design has seen a few iterations. Includes dual temp sensor readout for intake. Temps and pressure indications for 4 wheels and pc hookup for monitoring software. Also includes new blip controls.

Still on the hunt for a good HANS device.
__________________
2007 EuroSpec Z4///MC - Building/Developing Z4 GT3
Powered by

Last edited by Vanne; 07-05-2019 at 07:33 AM..
Appreciate 0