|
I just removed V3s off the car and installed the KW Clubsports last week. I set the front and rear perches to max then went for a quick drive and came back and measured ride height. Then I lowered the front and rear by an equal number of threads left to right and went for a drive and came back and measured.
I repeated the above process 4 times to get to desired ride heights. My left to right perches are almost at the same height (counting number of exposed threads below the perch).
My V3s were the same - left and right perches were almost at the same place. Front to rear were/are obviously different so cannot and should not be compared.
I have a Z4M with european headers instead of stock US that were heavier by about 10 lbs. other than that, the engine is stock.
|