|
I recently rebuilt my bottom end and installed the Z4 M HD Clutch and Flywheel kit from Turner. Its basically a Sachs pressure plate and a JB Racing Lightweight Aluminum Flywheel. I am getting the same vibration and noise in the 5500RPM range and its unsettling to say the least. Should be noted I also installed the RE stainless pivot pin as well.
In addition to the vibrations mentioned above, the clutch has a lot of rattle while in neutral with pedal out. Its also annoying af... i did know this was going to happen prior to install, just making sure others are aware of this.
I’m not sure what I’m going to do yet about this vibration, might go back to stock... any ideas would be helpful.
|