Huge frikkin day at the shed today.
I put off the secondary part of the brake master cylinder moving it upwards 25mm with brake ratio change.
Absolutely frikking "cee you next Tuesday" of a job...
Had to remove the pedal box to get access to the fire wall. Had to cut part of the firewall and the pedal box to make the new position for the master cylinder mount. Frikking drilled the first hole about 3mm off center... Grrr... Fixed that up and then redrilled the other holes. I drew up a plan and then went from there...
Pedal box on the inside.
After a bit of modify the firewall.
Mount.
And finally...
Then had to Dremel out the new portion of the firewall and notch a small bit of the pedal box frame as it fouls the piston rod.
Hell yeah... What an absolute mind crank that session. Was sooo nuked by the end of it.
Fingers crossed it all works like a champ. The new mounted position is absolutely solid as hell and the pedal box mounts to the original position so the pedals are in the required same spot. Absolutely shit to do job though. Did not enjoy that...
But it's done!!!
