|
Ok, you installed a new module. But, you retained the old micro switch. Is that correct?
The top will now go down .....is that correct?
However, when you push top up it stalls out about 1/3 way up and won't do anything. is that correct.
1st, when you did the top change out, did you relocate the motor to the trunk???
need that answer
2nd Please do this: Take the top down & put it up until it stalls, now WITHOUT engaging the red handle by-pass in the trunk attempt to manually push the top down. Please let me know how hard it was to do this. (if it's like a brick wall stop pushing)
3rd Please do this: Do the same thing as above but, after the top stalls engaged the hydraulic by-pass and move the top towards closing about 1 foot, now reengage the by-pass and push top close.
#2 is a hydraulic pressure test.....when you posted that you need to top off the hydraulic fluid I was a little concerned. In that, this is a sealed system.
#3 Is an electrical test for broken wires in the harness that's within the top. Basically, the top stops moving when it reaches the break and when you move it forward a little the wires reestablish contact and the top will move again.
|