|
|
SUPPORT ZPOST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
Post Reply |
|
Thread Tools | Search this Thread |
05-24-2014, 01:17 PM | #1 |
Private
6
Rep 69
Posts |
Inlet-Vanos error after new valvetoronic Seal?
I have recently changed the valve cover gasket, the eccentric shaft seal and the valvtronic motor seal. After i put everything together.
I also performed the valvtronic relearn procedure...long story short, the car still starts rough and threw the check engine light: Here is the error code I got: Error: 1(1) Nr: 10882 2A82 Inlet-Vanos (218) Moves with difficulty, jammed mechanically P-Code: P0012 'A' Camshaft position-Timing over Retarded ( Bank1) I looked around for that error code and it points to the Intake VANOS solenoid that needs to be replaced. Everything was running fine before, I am suspecting it's something with the valvetronic motor installation. Any idea how to remedy this situation? Last edited by rocky79; 05-24-2014 at 03:46 PM.. |
Post Reply |
Bookmarks |
|
|