|
|
SUPPORT ZPOST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
Post Reply |
|
Thread Tools | Search this Thread |
12-21-2022, 01:48 AM | #1 |
Registered
0
Rep 4
Posts |
Steering wheel button issues after installing an aftermarket stereo in my e85 z4
Hello so I've installed an alpine stereo in my z4 with a wire harness to retain the steering wheel buttons. I came across an issue where my steering wheel buttons work perfectly while my car is in the ON position, but when I start my car I then lose access to them, any help is greatly appreciated! BTW the wire harness I'm using is (SWRBM-57K) from crux.
|
12-21-2022, 07:26 AM | #2 |
Private
11
Rep 52
Posts |
I'll bet 'cha they https://cruxinterfacing.com/product/...us-k-line-bus/ could figure it out quicker than we could......
|
Appreciate
0
|
12-21-2022, 09:16 AM | #3 |
dances with roads
4732
Rep 4,096
Posts |
It is possible that you are taking your 12 volts from the wrong source. Different sources have 12 volts on or off depending on key position.
|
Appreciate
0
|
12-22-2022, 01:13 PM | #4 | |
Registered
0
Rep 4
Posts |
Quote:
|
|
Appreciate
0
|
12-22-2022, 01:16 PM | #5 |
Registered
0
Rep 4
Posts |
I was thinking this same thing, everything is wired how they want color to color, and I was looking at the instructions everything is how it should be, but only in the on position
|
Appreciate
0
|
12-22-2022, 01:24 PM | #6 |
Registered
0
Rep 4
Posts |
these are the diagrams, only ones it could be are red(ignition) black(ground) yellow(power) and maybe blue(power ant)
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|