|
|
SUPPORT ZPOST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
Post Reply |
|
Thread Tools | Search this Thread |
07-13-2012, 06:52 PM | #1 |
Second Lieutenant
20
Rep 250
Posts |
Too aggressive?
19"x8.5" ET20 front
16mm more inner clearance 28mm extend more I think they would stick out too far. 19"x9.5" ET20 Rear 4mm more inner clearance 16mm extend more 255/35/19 front, increase circumference from 81.58 to 81.74. 275/35/19 rear, increase circumference from 81.77 to 83.47. Probably too big. |
07-13-2012, 07:06 PM | #2 |
Dog Listener
711
Rep 7,850
Posts |
Rear isn't as much as issue as front. The offset is way to aggressive, most I'd go to avoid a major negative impact on handling, is ET32 (and then run camber washers and a lot of negative camber up front).
Basically changing offset affects scrub radius (suspension geometry). Stock offset is 42 front, and the lower you go the more it moves the scrub radius into positive from stock (negative). That's a really bad idea with a McStrut suspension, as in poor and unpredictable handing. Hack explains it much better than I can in this thread on exactly the same topic and offsets. |
Appreciate
0
|
07-14-2012, 12:29 AM | #3 |
instagram 997turbotom
296
Rep 7,381
Posts |
I think its possible with rolled fenders, BUT definitely not with those wide tires. You'd need something with a mild stretch
__________________
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|