FS: RE Diablo Mufflers

[jns_e85]

BIMMERPOST / Classifieds

Asking Price:

Sold

Item Interest

Up for sale are my RE Diablos that came off my Z4M. I absolutely loved these mufflers on my car with the US spec headers, but unfortunately after the addition of euro headers, they have become to loud for for my personal taste for daily use.

I am the second owner, and previously purchased these last year from another forum member. He had about 10,000 miles on them and I have added about 7,000 miles on them. Cosmetically, they aren't perfect (previous owner scraped or bottomed out at some point), however these imperfections are not noticeable when mounted. In terms of function, I have never had issues with them and they have worked well.

I have the 4 nuts required for installation and will be included with purchase. Everything is packaged and ready to go to a new home! Price is $850 or best offer, with shipping, insurance, and PayPal fees included. I will reduce price for a local buyer (as shipping alone is almost $100), and can ship to Canada if buyer is willing to pay the additional shipping charges.

Thanks for looking!

[jns_e85]

Mounted pic

[VindieselJetta]

Curious- what exhaust did you replace them with?

[jns_e85]

Originally Posted by VindieselJetta

Curious- what exhaust did you replace them with?

I am back to stock cans currently, however not for long

[mpathic]

Stock is ok, if the original x pipe and resonator are replaced with a large 2.5" in and out X pipe, and the square sections in the factory pipe by the inlet and outlet are expanded back out to being round again.
The factory x-pipe and resonator are the bad flow restriction. The mufflers flow quite well.
Next is to expand the pinched taper on the inlet of the stock muffler back out to 2.5", and for a bit more flow if needed, could cut open the side to remove the resonating pipe that's just inside the inlet. That pinched taper on the inlet is really the only flaw in the stock muffler flow vs aftermarket stuff.

[VindieselJetta]

Originally Posted by jns_e85

I am back to stock cans currently, however not for long

I assume you must be going to Remus, Stromung or Eismann?

[jns_e85]

Originally Posted by VindieselJetta

I assume you must be going to Remus, Stromung or Eismann?

Yup. At this point, I am strongly considering stromung and SS power loops. I do have a preference towards the stromung for a variety of reasons though (cost, weight, previous experience, etc.)

[jns_e85]

Sold!