|
|
SUPPORT ZPOST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
Post Reply |
|
Thread Tools | Search this Thread |
07-27-2023, 03:23 PM | #1 |
New Member
1
Rep 7
Posts
Drives: 08 3.0SI Black/Red Conv. Man
Join Date: Sep 2018
Location: SE Pennsylvania
|
Red light, no roof
I replaced the pump motor on my 08 Z4 without removing the roof. Now when I open the roof all is good. Roof actuates, goes into the well, led lamp goes out, motor stops. However the roof won't close. Motor runs but roof won't move. If I pick the roof up appox 1/4-1/2" then then try to close it, using the pump it does close. No problem. So now I open the roof, but stop just short of were the roof would stop automatically. But that means I drive around with that light blinking if I have the top down. Is there an adjustment or sensor that can moved to fix this?
Last edited by zperh; 07-27-2023 at 10:23 PM.. |
07-28-2023, 01:43 PM | #2 |
Private First Class
50
Rep 156
Posts |
There are two sensors on the hinge lifter located behind the drivers seat. You'll have to drop the top to see them.
Unless something is lose, I honestly wouldn't play with them. Your issue might be a sensor but, it also might be the start of the convertible controller going bad. Since the top is now coming down and with a little help going back up I wouldn't fool with it. |
Appreciate
0
|
07-30-2023, 01:38 PM | #3 |
Brigadier General
851
Rep 4,057
Posts |
In the trunk next to each hinge there is a black plastic knob. By rotating both of these knobs you can raise the dash in the rear window to make more cargo space in the trunk. Doing so locks out the roof motor.
Check to see that both knobs and the dash are fully in the lowest position. |
Appreciate
1
Aloyouis210.00 |
12-31-2023, 04:29 PM | #5 | |
Private
10
Rep 81
Posts |
Quote:
|
|
Appreciate
0
|
01-02-2024, 02:43 PM | #6 |
Brigadier General
851
Rep 4,057
Posts |
I’m delighted that you found this helpful. By the way, lots of other good info in the owners manual at https://cdn.dealereprocess.org/cdn/s...mw/2007-z4.pdf
Last edited by Huz-Z; 01-02-2024 at 04:46 PM.. |
Appreciate
0
|
01-02-2024, 07:47 PM | #7 | |
Private
10
Rep 81
Posts |
Quote:
I had downloaded the manual from another thread. Was that you too? |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|