Hey everyone I just had a z4m bumper installed on my z4 and have run into a problem with the splash guard/ underhood shield on the bottom of the engine compartment. I heard that the regular one's bolt holes will not align with the z4m bumper as its too short to reach, leaving about a 4 inch gap. Which is true as my splash guard did not align (or even reach) and while driving it the air pressure got up in that gap and ripped the guard in to pieces as it hanged off my car! So I was wondering if a z4m splash guard would fit a regular z4? Thanks so much and please excuse my lack of proper wording for this car part, as I hear it sometimes being referred to as a splash guard, dust/ oil pan and unhood shield. not sure which one is the more accurate title of the 3 though.
