|
|
SUPPORT ZPOST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
Post Reply |
|
Thread Tools | Search this Thread |
04-16-2011, 08:28 PM | #1 |
Enlisted Member
0
Rep 33
Posts |
M Coupe Alarm Retrofit
So I get the retrofit kit at my local dealership for 48 out the door. It has a built in tilt sensor in the siren. The hood switch went just fine. Found the wiring, intalled the mount, and was good to go. Then comes the alarm install behind the passenger rear tire. I followed the instructions, removed the tire, took out the fastners, and pulled the rear bumper most of the way off. Wow, no wiring harness for the alarm. Anyone have any helpful advise??? And yes, my car is supposed to be prewired according to my VIN
|
04-16-2011, 09:41 PM | #2 |
Colonel
1133
Rep 2,866
Posts
Drives: Anything
Join Date: Apr 2010
Location: SoCal
|
For the MC, The wiring for the siren is under the car in between the mufflers. See this for instructions => http://forums.bimmerforums.com/forum...d.php?t=913979
|
Appreciate
0
|
04-17-2011, 07:43 AM | #3 |
Major
28
Rep 1,110
Posts |
i was gonna say... i didnt remove the rear tire or the bumper whatsoever
__________________
2007 TiAg ///MCoupe
* Dinan strut bars * ZHP knob * RPI scoop * Ultimate Pedals * RE Diablo * 3.91 TMS gears * Apex PS7 * Eventuri intake* Nitto NT05 * TMS pullies * Zeck CDV * RE tranny mounts * Tekarbon * Mstache 2 * '14 Jeep Grand Cherokee Overland Hemi... No more snow for the M! |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|