|
|
SUPPORT ZPOST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
Post Reply |
|
Thread Tools | Search this Thread |
03-18-2014, 12:11 AM | #1 |
Second Lieutenant
17
Rep 251
Posts |
Meet My error code P2096
Here da baster.... for months and months I drove with my SES light on. Brought the car to a mechanic so they could run an EVAP (smoke test) and they were not able to find anything - cost me $95.
Then I found a video where a very cool dude from Canada uses a $40 party smoke machine and I decided to give it a try. Here are the pics of the problem which was a small hold around bank 2 sensor 2 bung. And to prevent removing the entire exhaust system just to replace the O2 sensors next time... I move them in front of the cats/section 1. I have a tune from ESS which allows me to run cat-less. 600+ miles after my ghetto fix and I haven't seen the light again Don't do this if you are not planning to get a cat-less tune. |
03-18-2014, 03:15 AM | #2 |
Captain
76
Rep 987
Posts |
You said it best. This is a ghetto fix.
__________________
CSL headers*Euro cats*Arqray exhaust*DKF hangers*Evolve Tune*Genuine CSL rims*10mm Macht Schnell front spacers*modified Hamann bumper*Tekarbon 2X2 CF spoiler*Turner CF grills*AS SSK*KWV3*OEM Strut bar*Rogue RSM*Polyurethane anti-roll bar bushings*Deka ETX30L battery*Nav Video module*front & rear cameras*Ipod module*stubby antenna*R-Dash LED license lights*LED Ziza interior lights |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|