|
|
SUPPORT ZPOST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
Post Reply |
|
Thread Tools | Search this Thread |
03-17-2014, 10:40 AM | #1 |
Colonel
352
Rep 2,176
Posts |
This is a full billet aluminum 2 piston ,caliper machine from a single piece of aluminum then split in two . Caliper is fastened with 4 mil spec bolts and nuts . This kit has been used on my Z4M track car with great success . The only reason I am selling is I upgraded to their larger rear setup after increasing my power to VT -2 525 levels . I am selling the calipers and rotors with PFC 08 pads( pads have approx 6 track days on them) and stainless steel lines . Don't hesitate to contact me if you need more questions answered. This kit is normally 2k without the cost of 08 pads . The rotors have seen track use so they have micro cracks but have plenty of life left in them . I am asking 900 , shipping included for these . George Last edited by gmd2003; 03-17-2014 at 11:50 AM.. |
03-17-2014, 12:55 PM | #4 |
Colonel
352
Rep 2,176
Posts |
|
Appreciate
0
|
03-17-2014, 12:57 PM | #5 |
Wagon life
39
Rep 991
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|