|
|
SUPPORT ZPOST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
Post Reply |
|
Thread Tools | Search this Thread |
01-28-2014, 09:18 AM | #1 |
First Lieutenant
94
Rep 303
Posts |
RPI Exhaust Install question
Hey Guys,
I'm relatively new to this and had a quick question since I will be installing my RPI exhaust this weekend on my 06 BMW Z4M. Can you back up a Z4M onto rhino ramps? I've done a lot of searching and have not been able to find any feedback pertaining to people trying to back these up on the ramps. I know pulling forward onto the ramp doesnt seem to work, but was hoping that backing up onto them will? Any insight from anyone who has tried would be helpful. These are the ramps i'm referring too: http://www.amazon.com/RhinoGear-1190.../dp/B006EGAIII Thanks everyone! |
01-28-2014, 04:08 PM | #2 |
Private
1
Rep 68
Posts |
If you can't get it onto the ramps usually you can just put down a 2x4 like so http://i215.photobucket.com/albums/c...s/IMG_0071.jpg and get it on there. I don't know how low you are though.
Also, this isn't so much a exhaust install question as it is a rhino ramp question ;p
__________________
RPI scoop, Euro headers, SS PowerLoop, Epic race tune, AKG motor/trans mounts, Turner camber bolts |
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|