|
|
SUPPORT ZPOST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
Post Reply |
|
Thread Tools | Search this Thread |
06-18-2011, 12:53 PM | #1 |
Brigadier General
3854
Rep 3,004
Posts |
07 Z4MR BMW Warranty Inspection 1 Complete....
Pleased w/the detail and expertise BMW Bellevue took w/my Red Roadster....
-The Red Roadster's mileage: 23,700 -4 Yr Warranty expires: Dec 2011 -Build date is Nov 06, so the 4.5 yr old battery was pro-actively replaced to prevent being stranded; replaced at my cost. -RF inner fender trim (black plastic piece appx 1 ft below the headlight) was cracked; replaced at my cost. -They honored my DO NOT WASH request -Nice loaner....2011 328 four door w/6 speed auto and paddle shifters Inspection 1 highpoints: -Adjust valves (no adjustment required after checking w/engine cold) -Four valve cover gaskets replaced -Anyone know what / why this was replaced and what it is?? 1 11-12-7-830-859 / Stud Bolt: 11109510 -Castrol synthetic oil change -Oil filter -Windsield washer antifreeze -Cabin activated carbon microfilter -Brake fluid flush -New brake fluid -Brake inspection -M Mobilitiy Kit tire inflating bottle replaced (every 4 yrs) ....and all normal vehicle / undercarraige / engine compartment / body / electrical equipment items listed on the BMW Service Maintenance Checklist
__________________
Racerbruce
|
06-18-2011, 01:07 PM | #2 |
Lieutenant General
2432
Rep 11,667
Posts |
did they give you the valve adjustment check sheet?
it should be included.
__________________
'21 M2C Hockenheim Silver
'18 718 Cayman S Lava Orange (sold) '13 E92 M3 Santorini Blue (sold) '07 Z4 M Coupe Alpine White (sold) |
Appreciate
0
|
06-18-2011, 01:38 PM | #3 |
Captain
64
Rep 666
Posts
Drives: 2023 Hyundai IONIQ 6 SEL AWD
Join Date: Aug 2007
Location: Seattle, WA
|
If they actually removed the valve cover to physically check the valves the work order should show these parts replaced:
Sealing rings, 6, 11-12-7-831-271 Cover gasket, 1, 11-12-7-832-034 Rubber grommets, 2, 11-12-1-437-395 Rubber grommets, 13, 11-12-7-830-972 Copper sealing rings, 2, 07-11-9-963-129 The stud bolt was replaced because they probably broke it off when tightening down the valve cover. If the grommets aren't replaced it's easy to over tighten the nuts as they are a contact torque against a sleeve inside the grommet. As pointed out above they should have provided you with a record of the valve clearance measurements.
__________________
Jim Millet
2023 Hyundai IONIQ 6 SEL AWD Ultimate Red SOLD: 2007 BMW Z4 M Coupe Imola Red |
Appreciate
0
|
06-19-2011, 10:20 AM | #4 |
Brigadier General
3854
Rep 3,004
Posts |
Thanks Jim -
All gaskets are itemized on the report except Copper Sealing Rings last #'s 129. I didn't receive valve adjustment info - will pursue - thanks.
__________________
Racerbruce
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|