|
|
SUPPORT ZPOST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
Post Reply |
|
Thread Tools | Search this Thread |
06-27-2012, 12:46 AM | #1 |
Captain
41
Rep 881
Posts
Drives: 95 M3, 15 i3, 17 M3 Frz Wht
Join Date: Jan 2007
Location: Chino, CA
|
SOLD: APR Wind Splitter - $225 Picked Up in LA
Hi All, Up for sale is a used APR Wind Splitter. There are scratches on both sides of the splitter but the ones that are on top are very small. I didn't even notice the scratches until I took the splitter off and inspected it. Everything else gets covered up by the bumper or are underneath. I just changed the front trim piece so this splitter is ready to be re-installed! Included with the splitter are 2 support rods and some hardware. You will have to buy some more hardware as I reused some of the parts. SOLD SOLD SOLD
__________________
Last edited by l4zy; 07-14-2012 at 12:53 AM.. |
06-27-2012, 06:01 AM | #2 |
Lieutenant
45
Rep 556
Posts
Drives: 2003 ESS TS1 Z4
Join Date: May 2011
Location: Muskegon, Mi
|
Wow, this is a good deal!
__________________
TS2/Cat-Less Headers/Jet Hot Coating 2000/CF Engine covers & Oil Cap/RPi Scoop/Matte Black Grills/H&R Sport Springs/15mm Spacers Rear/12mm Spacers Front/Flowmaster 40 series/Alcantara Shift Boot/CF Vinyl wrap/SPEC Stage 2+ clutch/8 Lbs Fly wheel/ZHP Shift knob/Hawk HPS Pads/Cross Drilled/Slotted Rotors/Performance Pedal Set/Stewart water pump
Love is like a fart; if you have to force it, it's probably shit. |
Appreciate
0
|
06-27-2012, 12:26 PM | #5 |
Lieutenant
45
Rep 556
Posts
Drives: 2003 ESS TS1 Z4
Join Date: May 2011
Location: Muskegon, Mi
|
This is for the M only correct? Or can it be applied to the non M?
__________________
TS2/Cat-Less Headers/Jet Hot Coating 2000/CF Engine covers & Oil Cap/RPi Scoop/Matte Black Grills/H&R Sport Springs/15mm Spacers Rear/12mm Spacers Front/Flowmaster 40 series/Alcantara Shift Boot/CF Vinyl wrap/SPEC Stage 2+ clutch/8 Lbs Fly wheel/ZHP Shift knob/Hawk HPS Pads/Cross Drilled/Slotted Rotors/Performance Pedal Set/Stewart water pump
Love is like a fart; if you have to force it, it's probably shit. |
Appreciate
0
|
06-29-2012, 05:55 PM | #8 | |
Lieutenant
551
Rep 541
Posts
Drives: 2022 X3MC
Join Date: Feb 2012
Location: Fairfax, VA
|
Quote:
__________________
'00 328i // Sold
'04 Z4 3.0i // Sold '22 X3MC LCI |
|
Appreciate
0
|
07-11-2012, 12:50 PM | #12 |
Major
78
Rep 1,443
Posts |
I've been looking at this and it's very tempting. Just out of curiosity, have you run this on the street or do you install just for autocross/track? I can't imagine clearing most driveway entries in SoCal with one of these installed.
|
Appreciate
0
|
07-11-2012, 01:17 PM | #13 |
Captain
41
Rep 881
Posts
Drives: 95 M3, 15 i3, 17 M3 Frz Wht
Join Date: Jan 2007
Location: Chino, CA
|
I keep it on for street too. You'd be surprised how much you can clear as long as you are taking dips and driveways angled. Sometimes I can't avoid scraping because there is no room to angle but the splitter doesn't really take much damage. It's mostly the support rod bolts that scrape the ground so as long as you keep swapping them you should never scrape away the splitter.
__________________
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|