|
|
SUPPORT ZPOST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
Post Reply |
|
Thread Tools | Search this Thread |
10-29-2022, 04:43 PM | #1 |
Banned
27
Rep 45
Posts |
OEM Exhaust Alignment
Hello,
I have a 07 z4m coupe. I just realized that the OEM exhaust is hanging lower than normal from the rear. Is there a way to adjust the position of the rear mufflers? Thanks |
10-29-2022, 04:48 PM | #2 |
Lieutenant Colonel
510
Rep 1,548
Posts |
Use the two bolts connecting to the x pipe to adjust. Tighten or loosen each bolt separately to adjust to your preference.
Also, by turning the flange to different positions to adjust the direction of the adjustment.. HTHs, .
__________________
FB Group-- > fb.com/groups/z4group Instagram --> @Skyermotorsport FB Page-- > fb.com/Skyermotorsport |
Appreciate
0
|
10-29-2022, 05:52 PM | #4 |
Colonel
1211
Rep 2,929
Posts
Drives: Anything
Join Date: Apr 2010
Location: SoCal
|
See this thread => https://www.bimmerpost.com/forums/sh....php?p=8832394
__________________
|
Appreciate
0
|
10-30-2022, 11:24 AM | #5 |
Major
503
Rep 1,016
Posts |
Yes, it can be baffling at start but at least in my car the way to get the mufflers to rise I had put the flanges vertically and started bolting the “top” bolt to the point I needed to back off as it was now too high. One side could not be risen as much but enough to look spot on.
You need to make sure all mounts and supports are still good. Otherwise you will be chasing your tail. Last edited by maupineda; 10-30-2022 at 10:50 PM.. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|