Quote:
Originally Posted by Jstic
That's it, two screws. Take them out and lower the cover, but don't pull it out yet. You have to disconnect a control box that is attached to the backside of that cover to be able to remove the cover. Just loosen one of the two nuts holding down the control box, take the other one out and you can slide the control box out. Once the cover is gone if you look up you will see the actuator and the 4 wire connector. The connector wires are green, blue, gray and white.
|
Sorry to slightly sidetrack this discussion. One of my two screws has gone missing. I took the screw to the dealer but they were unable to find a diagram of the panel that had the screw listed. They couldn't duplicate it.
Does anyone know what the P/N of these two screws is? Does anyone have a link to a diagram that includes these two screws?
Thanks, and back to the discussion.