First; since the install info above, I have had a few long runs at speed.
Everything worked nicely
2nd - The Lexan fill strip
I checked shipping to 23456, it's about $30. (UPS standard)
As expected the length drives the cost up a bit, but not too bad.
It looks like
$55 shipped would cover things.
I was planning to make a minor change to mine the next time I have to take the front end apart.
I would do away with the d.sided tape and instead drill up from the bottom & fasten with self tapping screws.
For this I would bond some additional blocks on the back (easier to target for drilling & a little more support)
So... You would get:
1. the fitted strip which is 1.5" high.
2. Wrapped in matte black 3M vinyl
3. 2 depth set stop blocks, which go behind @ each end (see pic above)
4. optional - if you want the 3 rear spacer blocks (pic) I can do that too. But you may be OK with your current spacers.
Material
- I only have enough Lexan for 3 more fill pieces.
- I have lots of vinyl
- I'm basically out of d.sided tape, but if you screw it in place it's not needed.
Looks to me like
Shipkiller,
F360C &
Finnegan have dibs on the last of the Lexan I have now.
If more are needed I can get more, but I may need a minimum order.