Quote:
Originally Posted by Beedub
... I'm going to re-use the bolts...
|
All the M10s are torque-to-yield.
They're the same as the front reinforcement plate (M10x35).
Also, one end of the "straps" is the same bolt, and the other end is M10x40.
All are torque to 58Nm plus 90°.
Just sayin'.
I was able to get my midpipes out without removing anything else.
I won't say it was easy, but I think it was easier than taking everything else apart.
I had to bend up a strip of steel to stick up between one of the copper nuts and the pipe, to jamb it in place and stop it from spinning.
I also used lots of extensions.