[ZStig]

I'll start with the software. During the ecu flash the fuel pump was whining loudly and the fuel needle swung to max. Was worrysome

Seems like when i coast to a stop, the rpm drops to a 900-1000rpm idle for about 10 secs. On 2 starts the idle was fluctuating between 500 and 1000rpm, car was coughing a little. On the highway the under light throttle the traction light came on and The throttle stopped responding for 3 seconds. Had a small throttle surge in 3rd gear too.

I'm worried about my aeromotive fuel pump a little. Hope it didnt get damaged during programming. I'm gonna re-set my throttle adaptation too

Hardware is a 83mm blower pulley, 135mm crank, different waterpump pulley so its not overdriven i think. Dont have my boost gauge in there at the moment. Only doing near redline pulls

So far its better than my badly slipping old pulley, especially up top.