Quote:
Originally Posted by gmd2003
It only flows better than stock at 80psi if it's getting enough power . Centrifugal pumps take a ton of juice apparently a stock system only provides 1/4-1/2 at best . The recommended Aeromotive wiring harness is a 30amp switch !!! Running them under power can make them fail early as well , which is why I was ok until recently . If ESS , AA, and VF say the regular pump is ok then I'm going back to it . Remember I was chasing the wrong pulley situation when I replaced mine . ( should have just changed my filter ) my two cents . Between my flywheel / clutch "upgrade " and this my new moto is if it ain't broke don't fix it lol . The problem of only improving one point of a stock system is the rest doesn't work together well . If you put in a lower bar fuel pressure gauge to make an aftermarket pump happy then you have to adjust the tune . It's a slippery slope .
My two cents
George
|
Are you still using your aeromotive pump, and did you upgrade the wiring yet? re-reading this thread, I think I need to, while I do the 525 upgrade...