Quote:
Originally Posted by DanFromTucson
I have a few questions for you sir:
1. Do these have the updated "quiet" rear dampers, or did they exhibit the moderate noise that others had reported in the past.
2. Do the upper shock mounts have the spherical bearings or rubber bushings?
3. Do you have the report from the rebuilder who dyno'd them?
4. And out of curiosity, do you know what the cost is for an eventual rebuild?
Thanks in advance!
|
1) If I recall correctly, the rears had the infamous valve tick noise under small undulations. But the fronts were reworked prior to my ownership and do not exhibit the same types of noises.
2) The rear shock mounts are Rogue Engineering, and use rubber bushings. At least one of which will need to be updated. I'm not sure if the RE RSMs can be used without their inverter thing, but I would replace the rubber bushing for peace of mind.
3) I do have the report (as it's the receipt for what I paid for their service). But it literally says the same thing: dynoed shocks and found to not need service
4) Cost for rebuilding is $250 per corner + shipping + any miscellaneous part(s) you may need
Let me know if you have any more questions
