Hey all,
Just wanted to share my Headers experience with you. I purchased a set of used SS V2 Stepped Headers from a member here. Had them Jet-Hot'd. Relocated my O2 sensors from stock location to Section 1. Performed my Baseline dyno after adjusting valves and an oil change. Installed the headers. No CEL or SES lights. Allowed the car to adapt for 1006 miles then headed back to the dyno.
49299 valve adjustment
49690 dyno (82*F 32% R.H.)
49710 headers
50716 dyno (95*F 36% R.H.)
I am at 63k miles now and still haven't had a single CEL or SES light because of the relocated O2 Sensors. I used all new gaskets FYI.
I love the extra power and sound. Only regret is, and this is my fault, I had them weld the relocated o2 sensors on the bottom of the section 1. Should of had them welded on the top of it. Enjoy!
