View Single Post
      06-03-2010, 09:21 PM   #15
onebluemcm
Captain
onebluemcm's Avatar
40
Rep
631
Posts

Drives: '07 Z4MC
Join Date: Apr 2010
Location: Richmond, VA

iTrader: (0)

To OP RE: rubbing issues at the bumper-quarter panel junction:

It may be more the offset and wheel width than anything. That 10.5" wheel with just a +22 offset is really aggressive. I also agree though, that on a 19" wheel, the 30 profile is probably optimal. Still, the wheel dimensions might be an issue for you. And you are lowered a bit too, right? That will just make an aggressive offset more likely to rub, but you probably knew that.

I could be off base on the wheel dimensions issue, but I did a ton of research on the subject when I was joining the RAC RG63 GB over on M3forum.net with the E46 guys, but for my M coupe. But I'm still no wheel expert....
Appreciate 0