Hi guys,
I am really getting close to finalizing my VF570 installation but I'm really stuck on hooking up all of the vacuum/boost lines. I am hoping someone with VF experience can help set me straight. I will reach out to VF, but it's the weekend
I am installing the VF570 with a Tial 50mm BOV, See attached photo.
1. This normally ties into the stock VF BPV. With the Tial I see no application for it. Cap it off?
2. Do I run a line from this down to the engine to drain any fluid, or something else?
3. This used to plug into the stock air box (elbow), I see no application for it now?
4. I am hooking up a boost gauge in the cabin, I believe I can get a boost reading off of this T?
5. Does this connect to the nipple on the bottom of the Tial (#7), or somewhere else?
6. Not sure what this elbowed nipple is for.
7. I installed the nipple that came with the Tial BOV I ordered from VF. Does this connect to #5?
8. This is a larger nipple, about double the size of #6. Not sure what application there is for this.
Thanks to all who can help provide insight.
