Is it possible to still get in on this? I have my apr splitter (uninstalled at this point) and like your creation!
[QUOTE=inTgr8r;9739614]
(more pics in the DIY thread)
In case you missed the discussion in the "DIY APR splitter Install thread";
I have been asked if I could make a run of the
fang fill piece that I made for my car.
I have enough material to make three more, which are already spoken for.
If there is enough additional interest in the fang fill piece, I will get material to do another run.
The Lexan fill strip
I checked shipping to 23456, it's about $30. (UPS standard)
As expected the length drives the cost up a bit, but not too bad.
It looks like
$55 shipped would cover things.
I was planning to make a minor change to mine the next time I have to take the front end apart.
I would do away with the d.sided tape and instead drill up from the bottom