Quote:
Originally Posted by inTgr8r
With OE RTABs to set the preload, you jack up the trailing arm to the normal position as if the car was on the ground.
Then tighten everything up.
|
But you can't fully tighten the center bolt after carrier is bolted to the car.
I'm leaning towards one of these two methods:
1. Install but don't fully tighten bushing to carrier
2. Raise wheel assembly to ride height
3. Bolt carrier to car
4. Unbolt carrier and mark position of bushing to carrier
5. Jam something between carrier and RTA to maintain position of carrier relative to RTA while tightening center bolt to
81 ft/lb
6. Bolt carrier to car
a. When lowering old bushing, mark position of carrier relative to RTA
b. steps 5 and 6 as above