[dre99gsx]

Been busy... Designed a small guage pod for my wideband gauge. This inserts into the CD slot. Temporary until I get the car tuned and setup


3D printed it at home on my one of a kind printer



Installed:



3D printed a small cover with grommet for passing wires through the firewall:



No room in this car for anything - had to fab up a firewall plate to mount wideband and boost solenoid:


Did I mentioned how tired I am of wiring??


Found some hard to find connectors/pins for the IVM module. This is needed to power up many other modules in the vehile.


Wiring harness coming along:



For some reason, Collins was dragging their feet getting me this darn pilot bearing adapter. I said screw it and just designed my own. I had a ProtoLabs machine it for me, came out great!



Turbo oil lines done. Engine primed with pressurized oil, ready to rock.


Fuel rail in. Ebay fuel rails SUCK. Had to modify this one to fit these injectors. Also, this is on a returnless fuel system (for now). Will deal with a proper fuel system later on...