Quote:
Originally Posted by WestCDA
Nice job! Amazing how that bulb fit into the existing chuck holder grooves in the drill housing - you'd think it was made for it!
|
"most" drills will accommodate a MR16 bulb just fine,
I've seen people put them in a bunch of different drills, mostly over at detailingworld.co.uk,
British site, But then again I am a Brit lol,
Just most of the drills they use are not available in the US so I had to do some searching for one over here that I could use,
and even though its a good thing, for this project its not, but most handheld powertools are 18v now,
Rare to see a 12v anymore,