[JJZ4MR]

The large plate on bottom of motor. In preparing to get my new constant pressure valve seal replaced I came across info on the 8 bolts that hold it in. Yes they are tightened to a particular torque, then turned an additional 90* and MOST people will say, they are NOT reusable. I'm not reusing them and shop owner confirmed this. I thought that using a 10.9 hardness rated bolt ( instead of OEM 8.8 ), would only make this better/stronger. This info is discussed when researching replacement of mounting bracket bolts being a known weak point of the motor mount issues. I purchased the mounting bracket bolts from Tri City, because I had all the dimensions. Maybe I should just stay with the OEM on the plate, just figured if I'm doing this, go with the best/strongest.