Quote:
Originally Posted by rjj
Yeah, I kinda gave up until I can scan the codes... On a sidenote, do you know if INPA would be sufficient to read those soft top codes? It's supposed to read K+CAN bus and that's where the soft top codes are stored apparently... I just don't know anything about those scanners so I'm still trying to piece things together in my head.
Antennahead, thanks for the thought. I'll check it again but I think I actually have an opposite situation... I have to pull the manual switch further than the position where it locks in order to release the hydraulic pressure.
|
My top would also move part of the way and stop. I'd hit the button and it would move a little more. I "thought" the pull switch was situated properly, but it was turned 180 degrees and not quite all the way in the housing where it rests...... pulled it out a little and got it in correctly, and the top started working again properly. I hope you can get to the bottom of it. These types of things frustrate the hell out of me