Quote:
Originally Posted by E86Z
Very cool, did you take pictures of the build progress?
|
not really in detail but did post some detials on my
garage journal thread
Quote:
Originally Posted by StigJ
Very interesting. More information please  |
V groove casters running on an angle iron that was cut into the Swisstrax floor so it sits flush with the floor. I had custom aluminum plates fabricated for the pads. My initial calculations were wrong and the aluminium bent up more then expected so now I have and get the ramps bent down a little more.
Quote:
Originally Posted by dbarton62
Ingenious
Nice one Adam
|
Quote:
Originally Posted by inTgr8r
Turned out great Adam!
VERY nice.  |
Now I just got to figure out how to motorize it. I was thinking using a winch motor and some type of screw or worm drive.