Quote:
Originally Posted by Dave 19103
Oh, and though the unit is known to be self-bleeding, once you install a new one I'd cycle it a few times and recheck level just to make sure; I had to do that with mine because I had been losing it out of the actuator and so the lines needed to be "re-filled" so to speak.
|
You are definitely correct. The unit is self bleeding and the level in the new motor is correct if there is no other issues (leakage), meaning the system has not been compromised with a faulty actuator or hydraulic line. If the system is compromised then you are also correct that after you fix all the issues, then bleed and a top off of the system may be necessary.
To everyone who has to top off, do not overfill. Mark the level in the reservoir before installation, then top off to that mark if needed. The system needs expansion room (returning fluid or thermal expansion) or it will become hydro-locked.