This is for the negative nancy who was saying I didnt know what I was talking about.....I just got an email back from MARK at ACPT and it says:
This looks like a shaft we could easily build, we would need some time on it though. I already have a similar shaft in line to be built. If you would like to send a shaft to use as a sample I think we could have a shaft done during August. We would need time to machine the splined part that fits the inner race of the CV joint and the 3 finger flex disc yoke.
We build the Corvette shafts now with great results, that shaft runs $799.00. I think your shaft would run in the $1200.00 range if we can get about 10 guys interested.
|