Z4M M3 S54 Fabspeed Headers by VAC
I'm moving and decided it will be easier to sell my VAC Fabspeed headers. They were on the car for a few thousand miles, but I'm in CA and have decided it's a bit of a bother. The were removed for smog and I've decide to sell rather than put them on again, although with the Evolve tune, they made a HUGE difference.
They are $1095 new, and were Jet Hot coated (~$500), and are in excellent condition as you can see from the picts. The website has a bunch of additional info, see:
http://store.vacmotorsports.com/fabs...ine-p2637.aspx
Highlights include:- High quality 14-16 gauge, T304 stainless steel, with the precision of computer controlled mandrel bent primary tubes
- Excellent fit and high precision welds that Fabspeed is known for
- Allows use of original S54 exhaust studs
- 38mm Primary runners with 50mm secondaries for excellent torque as well as top RPM HP gains
- Includes all new, needed gaskets, including for head and section one
- Fabspeed's signature 3-into-1 high velocity merge collector for improved exhaust scavenging
- Built in Secondary O2 spacers
- Excellent power gains ( Fabspeed Dyno tested at 24WHP and 24 Ft/lbs with performance software)
- Proper clearance and location of O2 sensor bungs & EGT sensor
- Fit both the SMG and 6speed manual transmission cars
- 3.5lb savings vs. stock exhaust manifolds
Website says these fit:
-'01-06 E46 M3,
-'01-02 E36/7 Z3M (S54 powered models only)
-'05-08 E85/E86 Z4M vehicles (Some heat-shield trimming may be needed)
$995 shipped to the lower 48. PM me if you have any questions!!