SOOOO I attempted this last night and it was a miserable failure.
I've changed my own tront control arms, brakes, suspension on this car myself so i figured this should be the easiest thing, but after yanking out the old cracked strip, I just could NOT squeeze the new one back in. I tried putting grease and soapy water, but nothing would make it seat correctly on the top. (sides were easy)
I ended up taking my car to a autoglass shop and even they had a very difficult time putting it in. The top line is not 100% flush, so they used some silicone to bond it and used tape that I'm leaving on to promote sticking, but one corners is slightly popping out.
Did anyone else have this issue?
|