You're in luck, typed this up for a friend. This is all the hardware involved.
Copper Collar Nut x 18 11 72 1 437 202
Header to the engine, 3 per pipe hence 18
Exhaust Manifold Gasket x 6 11 62 7 830 667
Gasket between header and engine
Exhaust Stud x 18 07 12 9 900 298
Studs on the engine for the headers
Exhaust Seal Ring x 2 11 62 7 830 668
Ring between headers and cats
Hex Nut (M10) x 4 18 30 1 317 898
Copper nuts between headers and cats
Exhaust Gasket x 2 18 30 7 830 674
Gasket between cats and x-pipe
Hex Nut (M8) x 6 11 62 1 744 323
Nut between cats and x-pipe
Quote:
Originally Posted by usaz4mcr8cr
also, will I need to wrap the O2 sensor wires to protect the from the heat after I unfold them? If so, what kind?
|
I used a cloth tape, check my mod thread in my sig. If I were to do it again I'd check CRFine's thread and just make extensions. He has pictures of them in
this post. You only need 10cm or so.
Quote:
Originally Posted by usaz4mcr8cr
If there are any additional parts that I may need please chime in.
|
You will need clips to fix the O2 wiring to the heat shield. I don't have a part number but check my mod thread for pictures of them.