View Single Post
      06-15-2010, 12:51 PM   #14
Lnick
New Member
0
Rep
5
Posts

Drives: z4 2.2 Manual
Join Date: Nov 2009
Location: Moscow

iTrader: (0)

Thank you so much for the post!!!!!!!!!!

I did it with my wife's "07 3.0Si

To make your manual even better, you can add
1. more info about soft top compartment floor clips (how to get'em back - it was tricky!).
2. more info on how to get the whole softtop out (actually i damaged my rollbar covers ;( doing this )
3. more info about unplugging wires (a have a preparation for hard top, so there was 1 more connector each side + that was the worst part of the work for me - getting them out of the clips)

Sorry for bad english and hello from Moscow!

And 1 suggestion: i suppose that the main cause of this problem is the old-school-bmw tape, that covers all hydraulic lines on the bottom part of motor housing. In my case - they were blocking the hole completely.

Last edited by Lnick; 06-15-2010 at 12:59 PM..
Appreciate 0