Quote:
Originally Posted by dekaliber
Looking for someone who has an M who knows 100% that they have never had any sort of front bumper work done to chime in here...
Could you measure the width of the 4 rivets on the inside of the front wheel well, fastening the wheel well lining to the front bumper?
(original photo by mister_roger, sorry for borrowing it)
I'd like to know if it's 15mm or 20mm.
The 20 mm ones are these blind rivets, which is what I found on my car. However, I think the previous owner had the original bumper resprayed, so I don't know if these were the same ones used from the factory. I was told by the parts person at my dealership that they should be these push-pin rivets, which are 15mm wide and match the ones shown in mister_roger's DIY. However, I'm not sure if the M's use the same ones.
I ordered the latter (the blind rivets are single-use), but they almost seem a little small for the holes and don't seem to secure as tightly as the blind rivets that were there before.
|
All 20mm on mine, bumper never removed.